AdblueOBD2 Emulator for VOLVO Trucks – Plug and Drive Ready Device by OBD2

AdblueOBD2 is a Plug & Drive Ready device to emulate working adBlue systems and NOx sensors on trucks equipped with EURO 4/5/6 catalytic converter systems—even when the adBlue SCR system is damaged.

Top 5 Reasons to Get AdblueOBD2 Emulator for Volvo Trucks

1. Easy Installation: Simply plug it into the OBD2 connector of your truck or bus and remove the specified fuses.
2. Instant Override: ADBlueOBD2 immediately overrides the ADBlue system, stops adBlue liquid consumption, and disables NOx sensors.
3. No Performance Impact: Operates without engine power loss or dashboard warnings, and leaves no fault codes in the diagnostic system.
4. Safe for Vehicle Systems: Does not damage the engine or negatively affect the truck’s factory settings.
5. Fully Reversible: Makes no permanent changes—restore original settings instantly by unplugging the device from the OBD2 port.

Installation and Calibration for Volvo Truck

1. Pull the key out from the ignition.
2. Remove the following fuse: VOLVO F10.
3. Plug AdblueOBD2 into the OBD2 connector.
4. Turn on the ignition and check the adBlue level—it should display 50% or 70%.
5. If any fault light appears on the dashboard, clear it using a service scanner.

Legal Notice

AdBlue/DEF (Diesel Exhaust Fluid) is used to reduce NOx emissions in vehicles. We recommend using adBlue/DEF fuel. This device may be used only if you are unable to locate a station to refill your adBlue/DEF tank.

Certifications

CE / RoHS

Package Includes

• 1 pc × AdblueOBD2 Emulator Box Interface
• 1 pc × User Manual (English)