Top-Selling Adblue Emulator for MAN Euro 6 Trucks

Adblue OBD2 Emulator for MAN Euro 6

EURO 6 AdBlue Emulator – Systems Disabled

• AdBlue system (fully disabled)
• AdBlue NOx sensor
• DPF system
• DPF temperature sensors
• DPF regeneration

Components That Can Be Removed After Installing the EURO 6 Emulator

• DPF sensors – YES
• NOx sensor – YES (only in DAF: do not remove the first NOx sensor!)
• AdBlue temperature sensor(s) – YES
• AdBlue pump – YES
• AdBlue level sensor – YES
• AdBlue ECU – YES

Note: The AdBlue system can be disabled by installing a programmable AdBlue emulator into the vehicle. The emulator can be switched on or off at any time.

Installation Guide for EURO 6 AdBlue Emulator – MAN Trucks

The MAN Euro 6 emulator does not require programming or learning. To install:

1. Mount the emulator under the metal cover of the AdBlue pump, located on the right side behind the cab.
2. Disconnect the plug from the AdBlue pump and connect it to the emulator.

Fuses to Remove During Installation

• F894 – Multisensor in AdBlue tank
• F738 – +30 signal of AdBlue pump
• F1084 – NOx sensor upstream

Fuse F737 is now dedicated to the emulator.
Fuse F1109 powers the downstream NOx sensor and the A1191 muffler temperature sensor. This sensor must remain operational for proper DPF regeneration.

Disabling Power to the Downstream NOx Sensor

You have two options:

1. Cut pin 1 in the NOx sensor plug, or
2. Remove pin 10 in the X3212 plug (recommended).
   This TE plug (16-pin with yellow key) is located on the rear of the engine on the right side.

Package Includes

1 pc × MAN EURO 6 AdBlue Emulator